PLANET GS-5220-48T4X - Manual (Page 300)

Command Guide
Default:
None
Usage Guide:
To configure the Access of SNMP
Example:
To configure the Access (below table) of SNMP
Switch# configure terminal
Switch (config)# snmp-server access default_rw_group model v2c level priv read
default_view write default_view
4.2.209 snmp-server community
Command:
snmp-server community { v2c [ ro | rw ] | v3 [
] }
snmp-server Set SNMP server's configurations
community Set the SNMP community
v2c SNMPv2c
Community word
ro Read only
rw Read write
v3 SNMPv3
Community word
IPv4 address
IPv4 netmask
Default:
None
Usage Guide:
To configure the Read / Write / Source network Community of SNMP
Example:
To configure the Read / Write / Source network Community (below table) of SNMP
-300-