PLANET GS-5220-48T4X - Manual (Page 244)

Command Guide
4.2.128 mep dm
Command:
mep dm [ multi | { uni mep-id } ] [ single | dual ] [ rdtrp |
flow ] interval last-n
mep Maintenance Entity Point
The MEP instance number.
dm Delay Measurement
Priority in case of tagged OAM. In the EVC domain this is the COS-ID
dual Delay Measurement based on 1DM PDU transmission.
flow The two way delay is calculated as round trip symmetrical flow delay. The far end residence time is
subtracted.
interval Interval between PDU transmission in 10ms. Min value is 10.
Interval value
multi OAM PDU is transmitted with multicast MAC.
rdtrp The two way delay is calculated as round trip delay. The far end residence time is not subtracted.
single Delay Measurement based on DMM/DMR PDU.
uni OAM PDU is transmitted with unicast MAC. The MAC is taken from peer MEP MAC database.
mep-id Peer MEP-ID for unicast DM. The MAC is taken from peer MEP MAC database.
Peer MEP-ID value
last-n The last N dalays used for average last N calculation. Min value is 10.
The last N value
Default:
0
Usage Guide:
To configure Delay Measurement of MEP
Example:
To configure Delay Measurement of MEP 1 as below table.
Switch# configure terminal
Switch (config)# mep 1 dm 5 rdtrp interval 10 last-n 10
-244-