PLANET FGSW-1816HPS - Manual (Page 39)

User’s Manual of FGSW-1816HPS
39
 Auto-Negotiation
Enable and Disable. Being set as Auto, the speed and duplex mode are
negotiated automatically. When you set it as Disable, you have to set the speed
and duplex mode manually
Enable – Start up the Auto negotiation.
Disable – Shut down the Auto negotiation
 Speed Select any available link speed for the given switch port. Draw the menu bar to
select the mode.
10M - Setup 10M Force mode.
100M - Setup 100M Force mode.
1G - Setup 1000M Force mode.

Duplex Select any available link duplex for the given switch port. Draw the menu bar to
select the mode.
Full - Force sets Full-Duplex mode.
Half - Force sets Half-Duplex mode.

Pause
When Auto Speed is selected for a port, this section indicates the flow control
capability that is advertised to the link partner.
When a fixed-speed setting is selected, that is what is used.
Current Rx column indicates whether pause frames on the port are obeyed.
Current Tx column indicates whether pause frames on the port are transmitted.
The Rx and Tx settings are determined by the result of the last Auto-Negotiation.
Check the configured column to use flow control.
This setting is related to the setting for Configured Link Speed.
Enable – Start up the flow control.
Disable – Shut down the flow control.
 Back Pressure Select the back pressure mode of the Port. Back Pressure mode is used with half
duplex mode to disable ports from receiving messages. Back Pressure mode is
enabled by default. The possible field values are:
Enable – Start up the back pressure mode.
Disable – Shut down the back pressure mode.
 Address Learning Switches remember the source hardware address of each frame received on an
interface, and they enter this information into a MAC database called a
forward/filter table.
Enable - Start up the Address Learning.
Disable – Shut down Address Learning.
 Select Port No. Select port number for this check box list.
Buttons
: Click to apply changes