Avago Technologies eXtremeRAID 3000 - Manual (Page 26)

Installation Checklist
2-4 eXtremeRAID 3000 Installation Guide
Installation Checklist
GET READY
☛
Note
It is recommended that you wear a grounded wrist
strap when working with hardware installation
procedures.
1. ____ Decide which available PCI slot will be used.
2. ____ Remove the plate from the I/O access port to the PCI slot.
3. ____ Remove the eXtremeRAID 3000 controller from the anti-static
bag.
GET SET
4. ____ Plug the eXtremeRAID 3000 controller into a standard PCI slot.
5. ____ Tighten the eXtremeRAID 3000 controller into the mounting
bracket.
6. ____ Connect the SCSI cable from SCSI drive(s) and/or SCSI
device(s) to the internal SCSI channel.
7. ____ Check termination - only for the internal SCSI channel.
8. ____ Check disk drives. Be sure termination is set to the disabled
position on any disk drive(s) that will not be terminated. For more
information, see the documentation that accompanied the disk
drives.
9. ____ Set SCSI ID on the SCSI disk drive(s).
10. ____ Enable termination power on SCSI disk drive(s).
11. ____ Insert the Fibre disk drives into a Fibre Channel Cabinet.
12. ____ Connect the Fibre HSSDC cable from the Fibre drive(s) to the
external Fibre loop channel(s).
☛
Note
Use only Fibre disk drives in your Fibre Channel
Cabinet.