Avago Technologies MegaRAID SATA 150-4 (523) - Manual (Page 19)

MegaRAID SNMP Configuration Guide B-1
Copyright © 1998-2003 by LSI Logic Corporation. All rights reserved.
Appendix B
SNMP Extension Agent
Trap Definitions
This apendix describes setting up the MegaRAID SNMP Extension
Agent using HP OpenView, and includes these topics:
•
Section B.1, “MegaRAID SNMP Extension Trap Definitions,” page B-
1
B.1 MegaRAID SNMP Extension Trap Definitions
The megaraid snmp agent supports a set of traps for any state change
in the controller and its attached devices. The traps depend on the
notification from the firmware. Following is a list of the traps supported.
There are no traps specific to LUNs as the megaRAID firmware does not
allow online removal or addition of luns and hence no notification from
the firmware.
Table B.1 MegaRAID Trap Definitions
Trap Number Trap Definition
9001 Configuration Updated
9002 Physical Drive State Changed
9003 Logical Drive State Changed
9004 Initialization Started
9005 Initialization Successful
9006 Initialization Aborted
9007 Initialization Failed