Avago Technologies MegaRAID SAS 8308ELP User Manual
Page 29

MegaRAID Device Driver Installation User’s Guide
6-1
Copyright © 2006-2007 by LSI Corporation. All rights reserved.
Chapter 6
SCO OpenServer 6 and
SCO UnixWare 7 Driver
Installation
This chapter describes the installation of the SCO
®
OpenServer™ 6
driver and the SCO UnixWare
®
7 driver, and consists of the following
sections:
•
Section 6.1, “Installing the Driver in a New SCO OpenServer 6 or
SCO UnixWare 7 System”
•
Section 6.2, “Upgrading the Driver on an Existing OpenServer 6 or
UnixWare 7 System”
6.1
Installing the Driver in a New SCO OpenServer 6 or SCO
UnixWare 7 System
When you install the SCO OpenServer 6 operating system or the SCO
UnixWare 7 operating system, insert the megasas Driver Supplement
media before you insert any HBA drivers supplied with your media kit.
Use the following steps on a SCO OpenServer 6 system or a SCO
UnixWare 7 system to create an HBA driver diskette from the HBA
diskette image file.
Step 1.
Go to the root directory, and create a new directory by typing
the following command:
$ su
Password: <type your root password>
# mkdir /tmp/hba
# cd /tmp/hba
Step 2.
Download the hba.megasas.1.0.image file to the newly
created /tmp/hba directory on your system.