beautypg.com

1 installing from cd, Installing from cd – Avago Technologies MegaRAID SAS 8308ELP User Manual

Page 27

background image

MegaRAID SAS Device Driver Installation User’s Guide

5-1

Copyright © 2006-2007 by LSI Corporation. All rights reserved.

Chapter 5
SUSE Linux Enterprise
Server (SLES) 9.0 and
10.0 Driver Installation

This chapter describes how to install the SUSE

®

Linux™ Enterprise

Server (SLES) 9.0 and the SUSE SLES 10.0 driver in the RAID-
configured drives. It consists of the following sections:

Section 5.1, “Installing the Driver in a New SuSE SLES Linux
System”

Section 5.2, “Updating the SuSE SLES 9.0 or 10.0 Driver”

5.1

Installing the Driver in a New SuSE SLES Linux System

Note:

If you use Service Pack (SP) 1 or SP 2, you need to load
the driver. If you use SP 3 RC 2, the MegaSAS driver is
already on the SuSE SLES Linux CD.

You can install the MegaRAID

®

device driver in a new SuSE SLES Linux

10.0 system from the SuSE SLES Linux CD. In addition, you can install
the MegaRAID device driver in a new SuSE SLES Linux 9.0 or 10.0
system from a floppy diskette.

5.1.1

Installing from CD

To install the driver in a new SuSE SLES Linux 10.0 system from the
SLES Linux installation CD, perform the following steps:

Step 1.

Boot the server with the SLES SP CD-ROM Disk 1.

The system BIOS must support booting from a CD-ROM. BIOS
settings might require changes to allow CD-ROM booting. See
your system documentation.

Step 2.

At the installation message, press ENTER.

The driver is installed from the CD.

This manual is related to the following products: