Chapter 3 novell netware driver installation, 1 novell netware driver files, Chapter 3, novell netware driver installation – Avago Technologies MegaRAID SAS 8308ELP User Manual
Page 19: Novell netware driver files, Megaraid novell netware driver files, Chapter 3

MegaRAID SAS Device Driver Installation User’s Guide
3-1
Copyright © 2006-2007 by LSI Corporation. All rights reserved.
Chapter 3
Novell NetWare Driver
Installation
This chapter provides installation instructions for the MegaRAID
®
Novell
®
NetWare
®
driver and consists of the following sections:
•
Section 3.1, “Novell NetWare Driver Files”
•
Section 3.2, “Installing the NetWare Driver in a New NetWare
System”
•
Section 3.3, “Installing or Updating the NetWare Driver in an Existing
NetWare System”
3.1
Novell NetWare Driver Files
The MegaRAID Novell NetWare driver and utilities support logical drives
configured on the MegaRAID controller. This driver supports up to 12
MegaRAID controllers.
Important:
The logical drives configured on the host adapter are
registered with the operating system as separate logical
units.
describes the MegaRAID Novell NetWare driver files.
Table 3.1
MegaRAID Novell NetWare Driver Files
Filename
Description
mega_sas.ham
This file is the MegaRAID host adapter module (HAM). This driver supports the NPA
Diagnostics option by using the NWDIAG flag, which is specified on the command
line when the driver loads. The driver is a re-entrant module. It registers one adapter
when you issue the Novell NetWare LOAD command to load the driver.
mega_sas.ddi
This file is the device driver installation file. It is needed to install the MegaRAID HAM
driver.