Avago Technologies Syncro 9361-8i - Manual (Page 11)

Avago Technologies
- 11 -
Syncro CS 9361-8i and Syncro CS 9380-8e Solution User Guide 
October 2014
Chapter 2: Creating the Cluster
Creating Virtual Drives on the Controller Nodes
Figure 1 VD Mgmt Screen
2. In the VD Mgmt screen, navigate to the controller and press the F2 key.
3. Press Enter.
The Create Virtual Drive screen appears, as shown in the following figure.
NOTE You can use the Create Virtual Drive dialog to create virtual drives for
Unconfigured Good drives. To create virtual drives for existing drive
groups, navigate to a drive group and press the F2 key to view the Add
New VD dialog. The fields in the Add New VD dialog are the same as
in the Create Virtual Drive dialog.
Figure 2 Create a New Virtual Drive
4. Select a RAID level for the drive group from the RAID Level field.
5. Enable the Data Protection field if you want to use the data protection feature on the newly created virtual drive.
The Data Protection field is enabled only if the controller has data protection physical drives connected to it.