Amprobe Multitest-2000 Continuity-Tester - Manual (Page 26)

AMPROBE
MULTITEST2000
----
Ω
R+ R-
----
Ω ----Ω
---mA ---mA
AUTO 0.11
Ω
FUNC CAL
A numerical value
in this field means
that the instrument
has been
calibrated; this
value remains on
the display for
any further
measurement
even though the
unit is switched off
and on again.
5. At the end of the test the result is stored and used as OFFSET (that is to say
that it is subtracted from any continuity test carried out) for all the
subsequent measurements.
Note:
The instrument performs the calibration only if the resistance of the test leads is
lower than 5
Ω.