Amprobe Multitest-2000 Continuity-Tester - Manual (Page 114)

AMPROBE
MULTITEST2000
8.8. MEASURING PROCEDURES
8.8.1. Using the Instrument in a Single Phase System
CAUTION
The maximum voltage between B1 and B4 inputs is 600 V~ (CATII) / 350V~
phase – earth or 600V~ (CATIII) / 300 V~ phase to earth.
Do not measure voltages exceeding the limits prescribed by this manual.
Should you exceed the voltage limits you could damage the instrument
and/or its components or endanger your safety.
Phase
Neutral
B1 B2 B3 B4
I1
I1
Instrument connection in a single-phase system
CAUTION
If possible, before connecting the instrument to the electrical equipment to
be tested take the power supply off the electrical equipment.