TA Triumph-Adler DC 2242 - Manual (Page 36)

FAX Operation (Basic)
OPERATION GUIDE 3-9
3
• 200 × 400 dpi (Super Fine): when sending
originals with minute characters and lines
Typical character size: 6 point (example:
Resolution
Resolution
)
• 400 × 400 dpi (Ultra Fine): when sending
originals with minute characters and lines more
finely
Typical character size: 6 point (example:
Resolution
Resolution
)
• 600 × 600 dpi (600dpi): when sending originals
with minute characters and lines as finely as
possible
Typical character size: 6 point (example:
Resolution
Resolution
)
NOTE: The default setting is 200 × 100 dpi (Normal).
The higher the resolution, the clearer the image.
However, higher resolution also means longer send
times. Normally, up to 400 × 400 dpi (Ultra Fine) is
recommended.
The machine does not support resolution of 300 × 300
dpi when sending faxes. If you have selected 300 × 300
dpi, the machine sends faxes after lowering the
resolution to 200 × 200 dpi (Fine).
The scan resolution should be equal to or higher than
the fax resolution. If the selected resolutions are not in
this condition, the machine automatically adjusts the
resolution and changes the selection.
1 To change the resolution, press [Color/Image
Quality], and then [Scan Resolution].
NOTE: You can see a preview of the image to be
sent by pressing [Preview]. For details, refer to
Previewing Images on page 3-34.
2 Select the resolution.
3 Press [OK].
Select fineness of scanning resolution.
The larger the number, the better the
image resolution.
400x400dpi
Ultra Fine
FAX TX Resolution
200x200dpi
Fine 200x100dpi
Normal 200x400dpi
Super Fine
600x600dpi
Cancel OK Add Shortcut
Status 08/08/2009 10:10
Preview
Original
Zoom
Paper
100%
---
:
:
: ---
Place original.
Place original.
Ready to send. Destination