TA Triumph-Adler DC 2075 - Manual (Page 241)

Section 9 TROUBLESHOOTING
9-11
2 Open the lower right cover to the copier.
3 Remove any jammed paper without tearing it.
* If the paper does happen to tear, remove any loose scraps
from inside the copier.
4 Close the lower right cover to the copier.
5 If necessary, reconnect the Side Feeder to the copier.
• Misfeed in the multi-bypass tray
If the message below is displayed, a misfeed has occurred in multi-
bypass tray. Perform the following procedure to remove the jammed
paper.
Inch specification
Paper misfeed.
1.Remove paper from Multi purpose tray.
JAM 00
Metric specification
Paper misfeed.
1.Remove paper from multi purpose tray.
JAM 00
1 Remove all of the paper remaining in the multi-bypass tray.
* If the paper is difficult to remove, do not attempt to force it.
Instead, refer to “ 2 Misfeed in the paper conveyor section”
on page 9-13 in order to remove the jammed paper.
2 Reset the paper in the multi-bypass tray.