TA Triumph-Adler DC 2075 - Manual (Page 224)

Section 8 OPTIONAL EQUIPMENT
8-4
4 Set the originals to be copied.
Verify the direction in which the originals were set.
5 Press the [Start] key.
Scanning of the originals will start and the number of
originals that was set will be displayed.
NOTE
If you do not set the originals in the Document Processor, perform the
appropriate procedure to set all of the originals to be copied.
Once all of the originals have been completely scanned, touch the
“Scanning finished” key.
6 Copying will start and each finished copy set will be
automatically stapled and ejected onto the Finisher.
7 Once copying is completed, removed the finished copy sets
from the Finisher.
4 Copying in the Hole Punch mode
1 Touch the “Function” tab and then touch the “Sort/Finished”
key. The “Sort/Finished” screen will be displayed.
Inch specifications
2 sided/
Separation Select
paper
Combine
Reduce
/Enlarge
Margin/
Centering Forms
Overlay
Page #
Function Basic User choice Program
Cover
Mode
Booklet
Sort/
Finished Border
Erase
Exposure
mode
Orig.image
quality
Ready to copy.
Select
orig. size
Auto
Selection Batch
scanning Up
Down
Set Paper size
11x8 1 / 2 "
Metric specifications
Select
paper 2-sided/
Split
Merge copy
Reduce/
Enlarge
Margin/
Imag. shift Page
numbering
Function Basic User choice Program
Cover
Mode Booklet Erase
Mode
Exposure
mode
Image
quality
Sort/
Finished
Ready to copy.
Select
size orig.
Auto
selection Large # of
originals
Form
overlay
Up
Down
Set Paper size
2 Touch the “Punch mode” key.
The “Punch” screen will be displayed.
Inch specifications
Sort:OFF Off
On Sort:ON
O f f s e t S o r t S t a p l e
Staple
mode
P u n c h
Punch
mode
Back Register Close Sort/Finished
Ready to copy.
Rear
Left top
corner
Check direction
Check direction of
original top side.
Set Paper size
11x8 1 / 2 "
Metric specifications
Sort:Off None
Output
each page Sort:On
G r o u p S o r t S t a p l e
Staple
Mode
P u n c h
Punch
Mode
Back Register Close Sort/Finished
Ready to copy.
Back Edge
Left top
corner
Check direction
Check direction of
original.
Set Paper size
IMPORTANT!
If the optional Hole Punch Unit is not installed in your copier, the
“Punch mode” key will not be displayed.
3 Touch the “2 holes” key or the “3 holes” key, as appropriate
(select between the “2 holes” key or the “4 holes” key in
metric specification copiers). The screen to select the hole
positioning will be displayed.
Inch specifications
Back Close Punch mode
Reset originals in processor.
None
2 holes
3 holes
Punch
Rear Left top corner
Check direction
Set Paper size
Check direction of original top
side.
11x8 1 / 2 "
Metric specifications
Back Close Punch Mode
Ready to copy.
None
2 holes
4 holes
Punch
Back Edge Left top corner
Check direction
Check direction of original.
Set Paper size