Epson 7500 - Manual (Page 48)

Saving Your Settings and Exiting SETUP
When you leave the SETUP program, you can choose to either
save the settings you have changed or exit the program without
saving any changes.
Follow these steps:
1.
Press You see the following prompt:
PRESS F5 TO SAVE AND EXIT
PRESS F1 TO EXIT W/O SAVE
2. If you want to save your changes, ress If you don’t
want to save your changes, press Either way, the
system reboots.
3. If you have just run SETUP for the first time, see “Post-SETUP
Procedures,” below.
Note
You may see an error message and a prompt to run SETUP
when your computer is rebooting if it detects a problem in
your SETUP configuration. If so, follow the instructions on
the screen to run SETUP and correct the problem.
You may also see an error message when your computer is
rebooting if you have not installed your operating system on
the hard disk and you have not inserted a system diskette in
drive A. If you receive this error message, follow the
instructions in your operating system manuals to install the
software on your computer.
2-22 Running the SETUP Program