Epson 7500 - Manual (Page 26)

4. If necessary, use the controls on your monitor to adjust the
brightness and contrast until characters on the screen are
clear and at a comfortable level of intensity. If your monitor
has horizontal and vertical hold controls, you may need to
use them to stabilize the display.
5. The screen displays the following prompt:
Press
Del to start SETUP
Do not press any key yet; you just want to make sure the
computer is working. This prompt appears every time you
turn on your computer so you can run SETUP if necessary.
After a few seconds, the prompt disappears.
If there is no operating system installed on your computer, you
then see an error message. Ignore the message for now;
once you install the operating system, you will not see this
message. If MS-DOS® is already installed, you may see the
command prompt (
C
:\) or the menu screen of a program
such as Windows, if it has been configured to do this.
Where To Go Next
If your system is preconfigured, the only thing you need to do
now is install any additional software and VGA device drivers
you want to use. (See your application program manuals for
instructions on installing software.) If you are using Microsoft®
Windows®, be sure to install the appropriate VGA driver(s) for
your monitor. See the VGA Utilities Guide for instructions. Then
see Chapter 1 of the User’s Guide for important information
about operating your computer.
If your system is not preconfigured, follow the instructions in
Chapter 2 to run the SETUP program. Guidelines at the end of
Chapter 2 tell you what to do next.
Setting Up Your System 1-15