beautypg.com

TA Triumph-Adler FAX 970 User Manual

Page 97

background image

6-20

Maintenance

Date en cours : 6 décembre 2000
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\DOC EN COURS\MFK 23260964-8 36xx Sagem GB\Maintenance.fm

0

,6&(//$1(286

,1&,'(176

At switch-on nothing appears on screen

Check that the mains cable is plugged in, and check the mains plug if necessary.

The message

N

O

P

RINTER

is displayed.

Check that the power switch of the printer is in the I (On) position (refer to paragraph Printer
connection
, page 1/12).

The fax does not detect the presence of your inserted document. The message

R

EADY

does not

appear on the screen.

At the start and during scanning,

R

EMOVE

D

OCUMENT

appears on the screen and the "On"

signal is red.

Remove the document or press key

.

Check the thickness of the document (30 sheets of paper of 80 g/m

2

).

Iron out the sheets if needed.

Help the sheets along.

The fax machine does not receive any faxes

• If the icon "Fax" is off and the icon "Tel." is on, this means that the reception mode is set on

M

ANUAL

. Set it to

F

AX

(refer to paragraph Reception modes, page 3/5).

Check that the telephone line cable is correctly plugged in and that there is a tone signal on the
telephone line.

• If the message

N

O

P

RINTER

is displayed on the screen, check if it is switched on, and check

that the printer connection cord is correctly plugged into the printer’s and fax’s jack.

You receive a blank page

Make a photocopy of a document ; if it is correct then your fax is functioning normally. Call back
the subscriber and have him resend the document. It was probably sent with the sheet inserted
backwards.

You cannot send a fax

Check that the telephone line cable is correctly plugged in.

Check tonality by pressing key

.

LIAISSE 23260966-9.book Page 20 Mercredi, 6. décembre 2000 5:45 17