TA Triumph-Adler FAX 970 - Manual (Page 22)

Installation
1-13
Op
er
a
ti
o
n
Set
ti
ng
s
Qu
ic
k u
sa
g
e
D
ir
ect
or
y
M
a
in
te
n
anc
e
Saf
et
y
Cont
en
ts
In
st
a
lla
ti
o
n
Date en cours : 8 janvier 2001
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\ARCHIVAGE DOC\MFK 23260964-8 36xx Sagem GB\Installation.fm
.
+
Make sure that the power switch is in the I (On) position.
Caution - Plug only the power pack supplied with your machine into the port (A) by means of
the main power cord (2).
7
(/(3+21( &211(&7,21
+
Plug end of the telephone line (4) into its jack on the fax machine (E), and the other end
into the wall telephone socket.
3
2:(5 /,1( &211(&7,21 $1' 6:,7&+ 21
Caution - Refer to safety procedures in the Safety Chapter.
+
Plug end of the main power cord (1) into the jack of the fax (B), and the other end in the
wall outlet
+
Set the switch (G) (depending on model) ti position 1 (On).
After a few seconds, when the printer has warmed up, the date and time will appear.
8
3'$7,1* 7+( &21680$/(6
A chip card is delivered with the consumables. This card initializes the system which enables you
to know at any time the toner cartridges consumption level.
After installing all the consumables in the printer, you need to inform the machine about their
features.
For this purpose, you must read the chip card provided with the machine, before using it.
The screen indicates:
INIT
INSERT GAUGE CARD
Installation.fm Page 13 Lundi, 8. janvier 2001 11:54 11