Rppxqlfdwlrqhuurufrghv, Hqhudofrghv – TA Triumph-Adler FAX 970 User Manual

Page 90

Maintenance

6-13

eration

Set

ting

Quick usage

Directory

Mainte

nanc

Safety

Contents

Installation

Date en cours : 6 décembre 2000
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\DOC EN COURS\MFK 23260964-8 36xx Sagem GB\Maintenance.fm

&RPPXQLFDWLRQHUURUFRGHV

The communication error codes appear in the logs and transmission reports.

*HQHUDOFRGHV

Code 01 - Busy or no fax answer

This code appears after 6 unsatisfactory attempts. Call later.

Code 02 - Burnt number

A number is burnt after 6 unsatisfactory transmission attempts. No recall is possible. You have to
validate the subscriber’s number a second time: refer to his record in the directory.

Code 03 - User break

A communication has been stopped by the user pressing the key

Code 04 - Non programmed number

A number saved as a one-touch key or abbreviated number is not valid: check it. (Example: a
delayed transmission was programmed with a one-touch key and this key has been deleted in the
meantime).

Code 05 - Scanning default

An incident occurred at the place where the document is placed to be scanned, for example, the
sheet is jammed.

Code 06 - Printer default

An incident occurred in the printer part: no paper, paper jam, opened cover. In the reception
mode, this incident appears only if the reception parameter no paper is switched to

ITHOUT

APER

(refer to paragraph Reception without paper, page 3/6).

Code 07 - Disconnected

The link has been cut (bad line). Check the call number.

Code 08 - Quality

The doucment you sent was badly received. Contact your subscriber to know if it must be sent
again. The disturbance may have occurred in an unimportant part of the document.

Code 0A - No document to be polled

You tried to poll a document from a subscriber who had not prepared his document (no deposit)
or the password entered was incorrect.

Code 0B - Wrong number of pages

There is a difference between the number of pages indicated during preparation for the
transmission and the number of pages sent: check the number of pages in the document.

Code 0C - Received document error

Ask the subscriber who called you to check the length of his document (it is too long to be
completely received).

Code 0D - Transmission failed

Ask the sender to retransmit the document.

LIAISSE 23260966-9.book Page 13 Mercredi, 6. décembre 2000 5:45 17