TA Triumph-Adler FAX 970 - Manual (Page 67)

5-12
Operation
Date en cours : 6 décembre 2000
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\DOC EN COURS\MFK 23260964-8 36xx Sagem GB\Utilisation.fm
+
Validate your setting by pressing key O K .
If you wish, you can change the origin of the flat-bed scanner (by default, this is the front left angle
of the scanner window marked with two arrows
1
)
By entering new values of X and Y given in mm (X < 210 and Y < 297), you will move the scanned
zone as shown on the figure below
.
+
Select the X and Y coordinates with keys
3
and
4
.
+
Set the required coordinates with the numeric keypad.
+
Validate your setting by pressing the O K key.
&RQWUDVW
+
Set the desired contrast with keys
3
and
4
.
+
Validate your setting by pressing key O K .
%ULJKWQHVV
+
Set desired brightness with keys
3
and
4
.
+
validate your setting by pressing key O K .
0DUJLQV
If you want to shift the side margins of your document to the left or to the right:
+
Adjust the left / right margin shift (in steps of 0.5 mm) with keys
3
and
4
.
+
Validate your setting by pressing key O K .
3ULQWHUVHWWLQJV
%ULJKWQHVV
If the printed document still appears too dark after setting the scanner, you can make it lighter.
+
Set the desired brightness with keys
3
and
4
.
+
Validate your setting by pressing O K .
1. Setting accessible on model 3610, yet the arrows are not visible
scanned area
y
x
LIAISSE 23260966-9.book Page 12 Mercredi, 6. décembre 2000 5:45 17