Rosen Aviation 0604 Series : Rosenview VX - Manual (Page 18)

Rosen Aviation RosenView VX Technical Manual
Document Number: 100640 Revision: G
Date: 9/19/12
Template: 4.4.1.6FM1; Revision A; 31 May, 2012 Page 18 of 23
5. TECHNICAL REFERENCES AND SUPPORT
Always check the Rosen Aviation website under the Products tab to
ensure than you are working with the most current revision of technical
documentation
.
Table 9 Technical references
Document Title Part Number Location
Universal Color Remote Control Contact Rosen Sales for part number availability
7-Button Controller 0300-407 www.rosenaviation.com
Disc Removal Tool 100690 Contact Rosen Tech Support
Disc Removal Tool Instruction 100691 Contact Rosen Tech Support
5.1. Troubleshooting
If the RosenViewVX does not function properly, refer to the following troubleshooting table for
symptoms and possible solutions before contacting Rosen Aviation Technical Support.
Note: Use an oscilloscope to verify the video signal. Always use a multimeter to verify voltages.
Check actual results against the requirements described in this manual.
Table 10 Troubleshooting tips and solutions
Problem Possible Solutions
No video 
Verify that a signal is reaching the display using an
oscilloscope or another display.

Verify that the display is turned on.

Verify that the pinout is correct.
Screen is black

Verify that the display is receiving power.

Verify that the pinout is correct.

Verify all connections between the source and the display.
Image flickers

Verify that the signal cable is secure.

Verify that the vertical frame frequency is 75 HZ or less.
Image is distorted 
Verify that the pinout is correct.

Verify that a signal is reaching the display using an
oscilloscope or another display.

Examine the display for pinched or damaged cables.
Nav Data LED is RED  No data is being received or there is a connection/wiring
error.
Nav Data is not being
displayed  Check ARINC or GPS input data/wiring.
IR control not working  Verify that IR control is enabled.
 Check IR wiring and pinout (external only).