beautypg.com

Front panel led, Source select menu – Rosen Aviation 7004 Series : 7 inch WideScreen User Manual

Page 25

background image

Rosen Aviation

7” Widescreen Display

Document Number: 106211

Revision: B
Date: 04/17/14

Template: 4.4.1.6FM2; Revision A; 12/06/12

Page 25 of 31

7.4. Front Panel LED

The Front Panel LED option turns the power LED on or off. When the option is Disabled, the
power LED will be black.

Figure 28 Front panel touchpad

When it is On, the power LED will have the following states:

Green indicates the display is receiving power.

Amber indicates the display is in standby mode.

Red indicates the display is registering an error.

Black indicates the display is receiving no power.

Highlight TechnicianFront Panel LED and press Menu.

Use the + and

to set the option Enabled or Disabled, and then press Menu.

Select Back and press Menu to return to the Technician Menu.

To exit the OSD, select Back and Exit.

7.5. Source Select Menu

Use this submenu to adjust the Pulse Width and Repeat Delay of the source select signal. Pulse
Width specifies the amount of time the pulse is active (when switching sources), and Repeat
Delay specifies the amount of time between pulses being sent from the display.

Highlight Technician MenuSource Select, press

to select a setting, and then press Menu

to access the option.

Use the + and

buttons to increase or decrease the length of time the pulse width and repeat

delay are active (in milliseconds), and then press Menu. The Pulse Width is always less than the
Repeat Delay.

Figure 29 Source Select menu options and their default values

Select Back and press Menu to return to the Technician Menu.

To exit the OSD, select Back and Exit.

Power LED