Rose Electronics QuadraVista II - Manual (Page 55)

QUADRAVISTA 2 INSTALLATION AND OPERATIONS MANUAL 49
Switching mode:
By default, switching mode is „manual switching with warning”. To change the switching mode use the arrow keys to
navigate to „CHANGE SWITCHING MODE” and press ENTER/SELECT.
Use arrow keys to choose one of the following modes to change the switching mode:
1. Manual switching with warning: This mode allows switching the USB port manually by selecting one of the
computers connected. But before executing the switching the following warning message is displayed: „In
order to prevent data loss, stop the USB device before switching!” To execute the switching press
ENTER/SELECT. This switching mode is recommended for USB devices with risk of data loss (e.g. USB
stick, printer, external memory)
2. Manual switching without warning: This mode allows switching the USB port manually by selecting one of
the computers connected. The switching is executed immediately. This switching mode is recommended for
USB devices without risk of data loss.
3. Automatically with active channel: In this mode, the USB device/port is always switched automatically with
the active channel. When switching channel/computer this USB device/port will automatically be switched to
the activated channel/computer.
Note: After power on, all USB devices are disconnected from computers except devices with
switching mode “automatically with active channel”.