RIGOL M300 User Manual
Page 63

RIGOL
© 2007 RIGOL Technologies, Inc.
User’s Guide for DM3000 Series
2-15
Limit Measurement
Use the Limit test function to perform pass/fail testing with respect to specified
upper and lower limits. The limits can be set to any value between 0 and ± 120% of
the highest range of the current function. The upper limit must be positive than the
lower limit.
Press
Limit, the display shows:
Figure 2- 12 Limit Setting
Table 2- 11 Limit Measurement Menu Function Description
Table 2- 12 Limit Parameters
Measurement
Description
DC Voltage
-1200V ~ +1200V
AC Voltage
0~ 900V
DC Current
-12A ~ +12A
AC Current
0~ 12A
Resistance
0 ~ 120MΩ
Capacitance
0 ~ 240uF
Frequency
3Hz ~ 300kHz
Period
3us ~ 300ms
Ratio
-1G ~ 1G
The range of Limit function:
(1). The upper limit value should be always greater than the lower limit value.
(2). The upper/lower limit values are stored in volatile memory.
Function
Menu
Settings
Description
High
Set the desired Upper limit.
Low
Set the desired Lower limit.
Save all changes, back to a higher level menu.