Example 7: reading hold, Example 7: reading hold -11 – RIGOL M300 User Manual

Page 115

RIGOL

User’s Guide for DM3000 Series

3-11

Example 7: Reading Hold

Do these steps as follows:

1. Connect test leads as shown in Figure 1- 7.

2. Press

button, select DC Voltage measurement function. Choose an

appropriate measurement range.

3. Set the Hold measurement function parameters.

(1). Press

 Auto  Hold  0.1%, set up the hold range to 0.1%.

Figure 3- 18 Hold Range Setting

(2). Press

to save all changes, back to a higher level menu.

4. When the

lights, press the button once, it will blink, which means the

trigger mode is now Hold mode. If current trigger mode is single, press the
button twice.

5. Lead test leads into circuit, start to measure.