Retrotec FanTestic (ATTMA) User Manual
Page 56
rev-2014-10-27
Page 56 of 58
©Retrotec Inc. 2011-2014
This means that you had a previous version of
FanTestic that was set up to “Run as
Administrator”, likely to allow connection to the
DM-2 gauges for automatic control over the USB
port.
create a new shortcut as described in the
if you
need to control DM-2 gauges
use the newly created shortcut if you are
not using DM-2 gauges
If you experience a problem that you cannot fix by troubleshooting, make sure you have the latest
version of FanTestic software installed, and that your Microsoft Windows has all the service packs and
updates installed (including .NET 4).
To install the latest automatically, connect to the internet and restart FanTestic – if there has been an
update since your current version, you will be prompted to download the latest updates.
However, if you have been using FanTestic running in Administrator mode, the “Check for Updates” may
not work correctly. To be sure you have the latest, you should go to the Retrotec website:
Then click on the Download button beside FanTestic. That will open a webpage which will show that
latest version. If this version is different than what you have installed, you should use Control Panel to