Retrotec FanTestic (ATTMA) - Manual (Page 25)

rev-2014-10-27
Page 25 of 58
©Retrotec Inc. 2011-2014
Calibrate gauge from calibration test data
If you are going to use this option, you will have data from a calibration lab that looks something like the
following:
In this sample data set, there are 11 target pressures. Each reading from the master gauge, channel 1
(or channel A), and channel 2 (or channel B) must be entered into the FanTestic “Gauge Calibration”
window.
If so, Select either “Calibrate your gauge from calibration test data” from the drop-down and the
following “Gauge Calibration” screen will pop up: