Oki MC363dn - Manual (Page 97)

Advanced network settings > 97
6. Enter a Name and a Description and then click Next.
7. Clear the Activate the default response rule (earlier versions of Windows
only). check box and then click Next.
8. Select Edit properties and then click Finish.
9. On the IP security policy properties window, select the General tab.
10. Click Settings.
11. On the Key Exchange Settings window, enter the value (minutes) in
Authenticate and generate a new key after every.
12. Click Methods.
13. On the Key Exchange Security Methods window, click Add.
14. Specify Integrity algorithm, Encryption algorithm, and Diffie-Hellman group.
15. Click OK.
16. On the Key Exchange Security Methods window, click OK.
17. On the Key Exchange Settings window, click OK.
18. On the IP security policy properties window, select the Rules tab.
19. Click Add.
20. On the Security Rule Wizard, click Next.
21. On the Tunnel Endpoint screen, make sure that This rule does not specify a
tunnel is selected and then click Next.
22. On the Network Type screen, make sure that All network connections is
selected and then click Next.
23. On the IP Filter List screen, click Add.
24. On the IP Filter List window, click Add.
25. On the IP Filter Wizard, click Next.
26. On the IP Filter Description and Mirrored Property screen, click Next.
27. On the IP Traffic Source screen, click Next.
28. On the IP Traffic Destination screen, click Next.
29. On the IP Protocol Type screen, click Next.
30. Click Finish.
31. On the IP Filter List wizard, click OK.
32. On the Security Rule Wizard, select the new IP filter from the list and then click
Next.
33. On the Filter Action screen, click Add.
NOTE
Specify the same value as Life time specified in the configuration for “Phase1
Proposal” in “Configuring your machine” on page 96 . Although Life time is
specified by seconds, enter a value by minutes in this step.
NOTE
Select the same value specified in IKE Encryption Algorithm, IKE Hash
Algorithm, and Diffie-Hellman group in the configuration for “Phase1
Proposal” in “Configuring your machine” on page 96 .