beautypg.com

Product certifications, Approved manufacturing locations, European directive information – Emerson 00825-0100-4075 User Manual

Page 21: Telecommunication compliance, Fcc and ic, Ordinary location certification for fm

background image

Quick Installation Guide

00825-0100-4075, Rev DA
July 2011

Smart Wireless THUM Adapter

21

P

RODUCT

C

ERTIFICATIONS

Approved Manufacturing Locations

Rosemount Inc. – Chanhassen, Minnesota, USA

Emerson Process Management GmbH & Co. - Karlstein, Germany
Emerson Process Management Asia Pacific Private Limited — Singapore

European Directive Information

The EC declaration of conformity for all applicable European directives for this product can
be found at www.rosemount.com. A hard copy may be obtained by contacting an Emerson
Process Management representative.

ATEX Directive (94/9/EC)

Emerson Process Management complies with the ATEX Directive.

Electro Magnetic Compatibility (EMC) (2004/108/EC

)

Emerson Process Management complies with the EMC Directive.

Radio and Telecommunications Terminal Equipment Directive (R&TTE)
(1999/5/EC)

Emerson Process Management complies with the R&TTE Directive.

Telecommunication Compliance

All wireless devices require certification to ensure that they adhere to regulations regarding
the use of the RF spectrum. Nearly every country requires this type of product certification.
Emerson is working with governmental agencies around the world to supply fully compliant
products and remove the risk of violating country directives or laws governing wireless
device usage.

FCC and IC

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions: This device may not cause harmful interference. This device must accept any
interference received, including interference that may cause undesired operation.This
device must be installed to ensure a minimum antenna separation distance of 20 cm from all
persons.

Ordinary Location Certification for FM

As standard, the transmitter has been examined and tested to determine that the design
meets basic electrical, mechanical, and fire protection requirements by FM, a nationally
recognized testing laboratory (NRTL) as accredited by the Federal Occupational Safety and
Health Administration (OSHA).

4075_QIG_Rev_DA.fm Page 21 Wednesday, July 27, 2011 8:50 AM