MCZ Athos MULTIAIR - Manual (Page 34)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page
34
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
4.9. HOT AIR VENTILATION
The Solar and Gea stove are equipped with an internal fan for
expulsion of heating air. It can be set to 5 different speeds at any time
regardless of the whether the stove is in manual or automatic mode.
To access the fan setting menu, press the button MENU 6 once and
the icon for ventilation will come on completely. In fact, normally
only the border of the symbol appears, since to access adjustment it is
necessary to access the corresponding menu.
5 speeds can be selected as well as an automatic function.
To select the speed, after pressing button 6, press button 5 up or down
to increase or decrease ventilation power. Variation of ventilation can
be seen by the number of bars above the fan symbol which will
increase or decrease as a result.
In addition to 5th speed there is an additional selection called AUTO
function. This function lets you connect the fan speed to the flame
power. With this option selected, the stove will independently select the
fan speed based on the flame power.
This option can be selected simply by again pressing the up arrow
button of button 5 once you are at the 5th ventilation speed. The
display of the remote control will show the message AUTO under the
fan symbol.
Example with ventilation set to AUTO:
If the flame is at power 3, the fan will automatically set to power 3. If
the flame is at power 5, the fan will automatically set to power 5, and
so on.
If the keypad is not touched for 7 seconds, the
remote control will automatically exit fan setting
mode and will confirm the last inserted setting.
In selecting the fan speed, it is advisable not to
select very low speeds (1st or 2nd) when the stove
is at maximum power as this may cause the
structure to overheat.
4.10. SLEEP FUNCTION
The purpose of this function is to make it faster to select a
programmed shutdown, without the need to programme the stove's
internal timer.
To explain the SLEEP function in simple terms, it might be said that it
allows the user to set a countdown starting from a minimum of 15
minutes up to a maximum of 8 hours, after which the stove will
shut off.
To set the function, press the MENU button 6 twice so that the icon
comes on completely.
Where the time is normally shown, 00:00 appears and it is possible to
choose the amount of time using button 5. Press the up arrow to
increase the time in steps of 15 minutes. Press the arrow down to
decrease the time in steps of 15 minutes. To confirm, press key 6 again
or wait 7 seconds.
After returning to normal operation, instead of showing the current
time, the display will show the countdown of time remaining to
shutdown.
AUTO
6
5
SLEEP