Epson FX-980 - Manual (Page 182)

A-12 Enhancing Your Printer With Options
R4C3430
Rev. C
A5 size APPA.FM
5/4/99 Pass 0
L Proof Sign-off:
_______
_______
_______
It is best to select the paper source in your application program
because software settings usually override the printer’s control
panel settings. However, if you cannot select the paper source in
your application, press the
Tear Off/Bin button until the lights
indicate the bin you want as shown below. When the printer
receives data, the cut-sheet feeder automatically loads the paper
from the bin you select.
Switching between continuous paper and single-sheet
paper in the cut-sheet feeder
You can easily switch between continuous paper on a push tractor
and single-sheet paper in the cut-sheet feeder without removing
the continuous paper.
Switching to continuous paper
1. If any sheets are in the paper path, press the Load/Eject button
to eject them.
2. Move the printer’s paper release lever to the front or rear push
tractor position. Also set the paper thickness lever to the
proper position for your paper.
3. Move the cut-sheet feeder’s paper selection lever to the
continuous paper position.
o n Bin 1 (the high-capacity cut-sheet
feeder) is selected.
n o Bin 2 (the second-bin cut-sheet
feeder) is selected.
n = on, o = off
G3-30-1.eps
G3-30-2.eps