Sealey AK9999 - Manual

2. iNTRODUCTiON & speCifiCaTiON
1. safeTY
InstructIons for:
miNi LaseR LeVeL UNiT
Model no :
aK9999.V3
thank you for purchasing a sealey Product. Manufactured to a high standard this product will, if used
according to these instructions and properly maintained, give you years of trouble free performance.
pLease ReaD THese iNsTRUCTiONs CaRefULLY. NOTe THe safe OpeRaTiONaL
ReQUiRemeNTs, WaRNiNGs aND CaUTiONs. Use THis pRODUCT CORReCTLY aND
WiTH CaRe fOR THe pURpOse fOR WHiCH iT is iNTeNDeD. faiLURe TO DO sO maY
CaUse DamaGe aND/OR peRsONaL iNJURY aND WiLL iNVaLiDaTe THe WaRRaNTY.
pLease Keep iNsTRUCTiONs safe fOR fUTURe Use.
1.1. GeNeRaL safeTY. read instructions carefully before using the laser level.
 DO NOT use this device in direct sunlight.
 DO NOT allow the level to get wet.
 DO NOT allow unqualified persons or children to operate this device.
1.2. LaseR safeTY. the AK9999.V3 utilises a class II laser that emits a low level of visible radiation
(i.e. a wavelength of 650 nanometres) which is safe for the skin but not inherently safe for the eyes.
the class II emission limit is set at the maximum level for which eye protection is normally
afforded by natural aversion responses to bright light. Accidental eye exposure is therefore
normally safe, although the natural aversion response can be overridden by deliberately staring into
the beam, and can also be influenced by the use of alcohol or drugs.
 DO NOT direct the laser beam at any person’s (or animal’s) eyes as eye damage could result.

DO NOT operate the laser level when you are tired or under the influence of alcohol, drugs or
intoxicating medication.
 Be aware that reflections of the laser beam from mirrors or other shiny surfaces can be as
hazardous as direct eye exposure.
Approved by VosA for the calibration of sealey HBs97 Headlamp Beam setter. Mini tripod can be placed on
bonnet or any surface of the test area. laser dot indicates if beam setter is in or out of calibration. Also suitable for
other levelling applications and features a magnet on base for attaching to ferrous surfaces.
speCifiCaTiON:
model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . aK9999.V3
laser Power: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ≤
1mW
Wavelength:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .650nm
Accuracy:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1mm/m
Batteries: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2xAAA (supplied)
© Jack sealey limited Original Language Version
AK9999.V3 Issue:1 05/12/13