Sealey WK01 - Manual

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY
AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
INSTRUCTIONS FOR:
WINDSCREEN REPAIR KIT
MODEL No:
WK01
1.1 GENERAL SAFETY
 WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this tool.
 WARNING! This kit contains glue. If you require a safety data sheet, contact your Sealey dealer.
 WARNING! Familiarise yourself with the specific applications and limitations of the kit, as well as any potential hazards.
 This kit should be used in conjunction with inspection maintenance procedures recommended in the vehicle manufacturer’s manual.
 Ensure that the kit is correct for the task.
 Wear the appropriate personal protective equipment for the task. A full range is available from your Sealey dealer.
 DO NOT use the kit for any purpose other than that for which it is designed.
 Ensure there is adequate lighting prior to using the kit. A range of inspection lamps are available from your Sealey dealer.
 Keep children and unauthorised persons away from the working area.
 DO NOT use the kit if any parts are damaged or missing, as this may cause failure and/or personal injury.
 DO NOT use the kit when you are tired, or under the influence of alcohol, drugs or intoxicating medication.
 After use, store in a safe, dry childproof area.
NOTE: If the damage is right in front of the driver - in the area known as 'Zone A' for MOT testing - damage up to 10mm diameter will normally result
in a MOT failure. Also damage greater than 40mm in the remaining swept area will normally result in a failure. Always refer to the latest MOT
information to make sure the repair is legal. Refer to fig.1. Zone 'A' is:
● in the swept area of the windscreen.
● 290mm wide.
● centred on the centre of the steering wheel.
1. SAFETY INSTRUCTIONS
Fig.1
2. INTRODUCTION
3. SPECIFICATION
Specialised windscreen applicator and resin, designed to penetrate deep inside chips and cracks giving an almost invisible repair. Reinforces the
damaged area preventing further spread and costly windscreen replacement. Uses a tough resin formula which can be used for multiple repairs.
Model No: . . . . . . . . . . . . . . . . . . . . . . . WK01
Maximum Chip Diameter: . . . . . . . . . . . 25mm
Maximum Crack Length: . . . . . . . . . . . . 15mm
WK01 Issue No.1 - 05/12/13 Original Language Version © Jack Sealey Limited