Sealey AK98941 - Manual

1.1 Safety Instructions

WARNING! Ensure Health & Safety, local authority and
general workshop practice regulations are adhered to
when using this tool.
 DO NOT use the suction cup if any parts are damaged or
missing as this may cause failure and/or personal injury.
 Before each use, check condition of suction cup. Examine
rubber pads for excessive glaze, cuts or roughness. If any
component is worn or damaged replace immediately.
 DO NOT clean the suction cup with solvents or other
harsh chemicals.
 Use genuine parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
 Use in a suitable work area. Keep area free from
unrelated materials and ensure that there is adequate
lighting.
 WARNING! Always wear approved eye, face and hand
protection when using the suction cup.
 Remove ill fitting clothing. Remove ties, watches, rings,
other loose jewellery and contain and/or tie back long hair.
 Maintain correct balance and footing. DO NOT over reach,
ensure the floor is not slippery, wear non-slip footwear.
 Keep children and unauthorised persons away from the
working area.
 Ensure workpiece is secure before attaching and using
the suction cup.
 WARNING! Ensure that the surface to which the suction
cup is to be attached is non-pourous, clean, dry and free
from oil and grease.
 DO NOT exceed the maximum pull capacity of the suction
cup.
 DO NOT use the suction cup for any purpose other than
that for which it is designed.
 DO NOT use the suction cup when you are tired or under
the influence of alcohol, drugs or intoxicating medication.
 When not in use, store in a safe, dry, childproof location.
 DO NOT use any sharp object to loosen the suction
cup as it may damage the rubber and prevent the tool
from creating suction.
 DO NOT attempt to attach the suction cup to a person as
severe bruising and/or damage to internal organs can
occur.
 DO NOT allow anything to interfere with the free
movement of the plunger whilst the suction cup is
attached to a surface.
 Keep fingers clear of suction release tag during use.
 DO NOT allow anything else to touch the release tab
whilst in the process of lifting e.g. other lifting gear or
adjacent fixtures and fittings.
InStRUctIonS foR:
VACUUM SUCTION CUPS - 40kg
ModEl no's:
Ak98941 & Ak98942
thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/
OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE kEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2. INTRODUCTION & SPECIFICATION
Ak98942 is a profiled rubber suction cup suitable for
attachment to CURVED SURFACES such as windscreens.
Red line indicator warns of any vacuum loss. can also be used
on smooth, non-porous flat surfaces such as glass, sheet metal
and tiles.
Original Language Version AK98941, AK98942 Issue: 1 - 23/07/12 © Jack Sealey limited 2012
Model No: Ak98941 Ak98942
Size: Ø178mm Ø178mm
Maximum Lift Capacity: 40kg (horizontal) 40kg (horizontal)
Ak98941 is a rubber suction device with a red line indicator
which warns of any vacuum loss. Easy attachment on smooth,
non-porous FLAT SURFACES such as glass, sheet metal and
tiles.