Sealey VS0286 - Manual

VS0286 - Issue: 2 - 23/09/10
INSTRUCTIONS FOR:
BRAKE WIND-BACK
tool KIt 29pc
MODEL NO:
VS0286
2. INtRoDuCtIoN
Air operated wind back tool suitable for left or right hand wind back operations. Fast, lightweight and easy to use. Master set of
adaptors suit a wide range of vehicle applications. Suitable for push-back and wind-back brake pistons. Left-handed thrust required
for Ford, Citroen and Renault applications. Interchangeable adaptor plates with thrust bolt assembly and reaction plate. Includes
3/8”Sq drive adaptor and 2-pin magnetic adaptor for added flexibility. Kit helps prevent damage to pistons and seals.
 WARNING! Ensure all Health and Safety, local authority, and general workshop practice regulations are strictly adhered to
when using tools.

Do Not use tools if damaged or worn.
 Maintain the tools in good and clean condition for best and safest performance.
 Ensure all threads are clean and well lubricated.
 Ensure vehicle is adequately supported with axle stands, ramps, etc. as appropriate.
 Wear suitable clothing to avoid snagging. Do not wear jewellery. Tie back long hair.
 Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.
 Account for all tools and parts being used and do not leave them in or on the vehicle.
IMPORTANT: Always refer to the vehicle manufacturer’s service instructions, or proprietary manual, to establish the correct
procedure and data. These instructions for use are provided as a guide only.

WARNING! the warnings, cautions and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood that common sense and caution are factors which
cannot be built into this product, but must be applied by the operator.
1. SAfEty INStRuCtIoNS
fig.2
3. SEt up & opERAtIoN
3.1 Set up
3.1.1 Remove the wind back tool from the carry case and fit the 3/8" adaptor (5).
3.1.2 Select the appropriate adaptor using the application chart (overleaf, Section 5), attach this to the 3/8" adaptor.
3.1.3 Select the correct calliper plate and attach this to the wind back tool. (fig.2)
3.1.4 Connect an air supply to the air inlet on the bottom of the tool using
the recommended set up right (fig.1).
3.1.5 Set the regulator on the compressor to 90PSI.
3.2 operation
3.2.1 Squeeze trigger to apply pressure on the calliper piston.
3.2.2 When applying pressure on the piston turn the wind back handle to
rotate and compress the piston; the handle can be turned
either way depending on the design of the calliper.
3.2.3 Push the pressure release button to retract the tool.
fig.1
4. mAINtENANCE
4.1 Lubricate the tool daily with a few drops of sealey air
tool oil dripped into the air inlet. Lightly oiling the wind
back shaft will prolong the life of the tool.
4.2 After use clean the tool with a damp cloth and mild
detergent to remove any dirt and grime.
4.3 When you are finished with the tool store it in a dry,
safe, childproof location.