Sealey TA310 - Manual (Page 3)

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park ,
Bury st. Edmunds, suffolk,
IP32 7Ar
01284 757500
01284 703534 [email protected]
www.sealey.co.uk
Web
email
© Jack sealey Limited 2013 Original Language Version
tA310 & tA311 Issue: 1 - 18/03/13
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or phone 01284 757500.
5. MAINTENANCE
 WARNING! DO NOT attempt to repair or service unless you are qualified to do so and have the relevant calibration, performance test,
and service information. to avoid electrical shock or damage to the meter do not get water inside the case.
5.1. Periodically wipe the casing and jaws with a damp cloth and mild detergent. Do not use solvents.
5.2. turn off when not in use and remove the battery if stored for a long period of time.
5.3. DO NOT store in a place of high humidity or high temperature.
5.4. Replacing The Battery (fig.2)
 WARNING! to avoid electric shock, disconnect the circuit probes from the multimeter before removing the battery cover.
5.4.1. When the battery becomes exhausted or drops below the operating voltage, the red LED battery symbol will be illuminated.
5.4.2. open the battery cover by loosening the screw using a small cross head screwdriver.
5.4.3. remove the old battery and insert the new one, observing the correct polarity clearly shown inside the compartment.
5.4.4. replace the battery cover and secure with the screw.
5.4.5. Dispose of batteries according to local authority guidelines.
Environmental Protection.
recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a recycle centre and disposed of in a manner which is compatible
with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way.
contact your local solid waste authority for recycling information.
open battery compartment as described in section 5.4. Disconnect battery and remove.
D ispose of batteries according to local authority guidelines.
under the Waste Batteries and Accumulators regulations 2009, Jack sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme.
Jack sealey Ltd’s Batteries Producer registration number (BPrn) is BPrn00705
remove to replace battery
underside battery compartment. Read the warning
on the battery compartment cover before opening.
fig.2