Sealey TA126 - Manual (Page 2)

3. OPERATION
4. MAINTENANCE
4.1 Battery Replacement
Power is supplied by a 9V PP3 battery. The ‘ BAT’ symbol appears on the LCD display when
replacement is required.
p
WARNING! To avoid electric shock ensure all inputs are disconnected from any circuit before
removing the battery cover.
4.1.1 To replace the battery, remove the screw from the back of the unit and remove the cover.
4.1.2 Remove the exhausted battery and replace with a new one observing the connection polarity.
4.1.3 Replace cover and secure with screw.
4.2 Cleaning
Clean using a soft damp cloth.
Store in a safe, dry, childproof location.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version TP126 Issue: 1 - 06/06/11
01284 757500
01284 703534 [email protected]
www.sealey.co.uk
Web
email
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a recycle centre and disposed
of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective
way. Contact your local solid waste authority for recycling information.
Battery Removal.
See Section 4.1 for battery removal.
Dispose of batteries according to local authority guidelines.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform
potential purchasers of products containing batteries (as defined within these regulations), that they are
registered with Valpak’s registered compliance scheme.
Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705
3.1 Measuring
3.1.1 With the vehicle ignition OFF, remove the fuse from the circuit to be tested and insert it into the fuse
jack (fig.1.9) of the connector to be used, this ensures the correct level of circuit protection.
3.1.2 Attach the connector to the tester ensuring the banana adaptors are matched (i.e positive to
positive / negative to negative)
3.1.3 If required switch on the vehicle ignition to energise the circuit and then switch on the TA126.
Press the On/Off button (fig.1.4).
3.1.4 Operate the circuit under test and the LCD will display the measured current.
3.1.5 When finished press the On/Off button (fig.1.4) to turn off the tester.
p WARNING! The Fuse blade may become hot during testing. Allow to cool before removing.
3.2 HOLD Function
The Hold function allows the meter to freeze a measurement for later reference.
3.2.1 Press the HOLD button to freeze the reading on the LCD display. The HOLD message will
appear in the display.
3.2.2 Press the HOLD button again to return to normal operation.
3.3 ZERO Function
The Zero function allows comparison and offset readings of current.
3.3.1 Press the ZERO button to reset the displayed figure to 0.00.
3.3.2 Press the ZERO button again to return to the actual current reading.