Sealey ATV1135 - Manual (Page 3)

3. INSTALLATION
3.1 WINCH INSTALLATION
3.1.1 Mount the winch on the vehicle or other fixed installation by using M8x1.25x30mm screws, M8 nuts, Ø8mm flat and spring washers.
 WARNING! Mount the winch so that the wire rope underwinds. Improper mounting could damage your winch and void your
warranty. see fig.4.
Fig.5
3.2 ELECTRICAL INSTALLATION (Refer to fig.5)
 WARNING! these winches work on standard automotive 12V Dc only, never connect to a 230V mains, as solenoid burnout or fatal
shock may occur.
Make sure the battery is disconnected.
3.2.1 Plug the switch plug into the switch socket. Plug the green wire into the green wire on the relay block and the black wire into its
connector on the relay block.
3.2.2 connect the red wire to the red marked terminal on the relay block and to the positive (+) terminal of the battery. connect the black wire
to the negative (-) terminal of the battery.
Fig.4
Grn
Grn
BLK
BLK
Grn
BLK
rED
rED
WH
t
BLu
rED
BLK
YLW
M
YLW
+
-
PLuG socKEt
connect 3 wires
to ignition switched feed.
remote hand held
control "In/out".
Handlebar bracket fixed
control "In/out".
relay
BLu
12v
Bulkhead
AtV1135, AtV2040 Issue: 2(I) - 29/01/14 Original Language Version © Jack sealey Limited
WIRING CONNECTION DIAGRAM
Fig.5
Pos
nEG