Sealey WD202 - Manual (Page 4)

The owner and/or operator shall study these instructions and retain them for future use.
a)
Understanding instructions and warnings.
the owner and/or operator shall understand the operating instructions and warnings before operating the crane.
Warning information must be emphasised and understood.
If the operator is not fluent in English, the product instructions and warnings must be read to, and discussed with, the
operator in the operator’s native language by the owner, making sure the operator understands the contents.
b) Damaged Cranes.
Any crane which appears to be damaged, badly worn, or operates abnormally Must BE rEMoVED froM sErVIcE!
It is recommended that necessary repairs be made by an authorised service agent.
c) End of service.
through years of normal wear, the crane will eventually become unserviceable. When this happens ensure the hydraulic oil is drained
off and disposed of in accordance with local authority regulations.
6. OWNER’S & OPERATOR’S RESPONSIBILITIES
Your crane is guaranteed for one year from the date of purchase. the Guarantee does not cover faults caused by incorrect use, lack of maintenance,
accidental damage or damage caused to third parties through misuse. You are recommended to inform your insurers and check that adequate cover is in place.
Warranty claims must be supported by a copy of the dated purchase receipt.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park ,
Bury st. Edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Web
email
h) Lubricate the locking studs then screw into the ram, see fig.5.
i) Inset the safety system handle from one side through the long spacer and secure with nut, see fig.6.
j) When the safety system is assembled tighten the pivot bolt (fig.4). After tightening, undo the bolt 1.5 turns, this releases the safety
system to move freely (fig.7).
k) Place the jib extension (fig.3D) over the arm (fig.3c) so that the head of the hex socket bolt protrudes through one of the 3 holes in
the top surface of the extension. retain the jib with pin (fig.3.5) which passes under the arm and secure with circlips.
l) PRIME unit before first use as follows:
Move the pumping handle into a horizontal position and manually depress the release lever (see fig.1) to the bottom of its travel.
Keeping the release lever depressed, pump the handle up and down 5 to 6 times. release the lever, the crane is now ready for use.
5.2 STORAGE.
a) Always store the crane fully closed so that the jib is in lowest position and the ram is closed.
© Jack sealey Limited
Original Language Version WD202.V3 Issue no: 1 - 20/06/12