Sealey DFS55 - Manual (Page 5)

Cartridge filter .................................Model No. Dfs55.02-42
fine Particle filter ................................Model No. Dfs55.04
Dust Collection Bag .........................Model No. Dfs55.05-18
IMPORTANT! IF THE MACHINE IS USEd WITHOUT A
FILTER FITTEd THE MOTOR WILL BURN OUT
EVENTUALLY ANd YOUR GUARANTEE WILL BE
INVALIdATEd. ALWAYS KEEP SPARE FILTERS HANdY.
8.3.3 To clean a dry filter, tap it inside a waste bin.
8.3.4 To clean a wet filter rinse it with water. If the dirt is stubborn
the filter can be brushed with a plastic brush and rinsed with
water again. Do not use a metal wire brush as this will
damage the filter.
8.4 FINE PARTICLE FILTER MAINTENANCE.
8.4.1 Clean in the same way as the cartridge filter. If the filter is
rinsed in water it must be thoroughly dry before it can be
used again.
NOTE: Blocked filters and/or over filled bags may damage the motor
and will invalidate your warranty.
 WARNING! dO NOT operate the system without a filter
or dust bag. Always ensure you use authorised spares,
filters and bag. Contact your Sealey dealer for details.
 WARNING: The warnings, cautions and instructions
discussed in this instruction manual cannot cover all
possible conditions and situations that may occur. It
must be understood that common sense and caution are
factors which cannot be built into this product, but must
be applied by the operator.
8.5 AIR INLET FILTER. (See fig.7)
8.5.1 The air inlet filter should be cleaned on a regular basis to
ensure efficient operation of the unit.
8.5.2 Remove the air filter cover (C) from the power head by
pressing the release button (D) and tipping the cover
backwards and lifting it off.
8.5.3 Pull out the filter holder (B) and remove the foam filter (A).
8.5.4 Wash the foam filter in warm soapy water to clean it. Rinse it
in clear water, squeeze thoroughly and leave to dry.
8.5.5 Insert the foam filter back into the filter holder and insert the
holder into the aperture in the head. Push fully home.
8.5.6 Insert the two tabs on the bottom of the filter cover into the
slots in the bottom of the filter aperture. Hinge the cover
forwards and snap it into place.
PROBLEM CAusE sOLuTION
1)
Cleaner
will not
operate
1a) No power supply Check supply
1b) faulty power cable,
switch or motor
Check and repair or replace
faulty item
1c) Container full of
liquid
Empty container
2) Dust
comes
from the
motor
cover
2) Cartridge filter
missing or damaged
Fit or replace cartridge filter
3)
Reduced
efficiency
and
increased
motor
speed/
vibration.
3a) Dust container full Empty container
3b) filter clogged Clean or replace cartridge
filter
3c) Nozzle, hose or
container inlet blocked
Check nozzle, hose &
container inlet for blockage
fig.7
10. CONSUMABLES
9. TROUBLESHOOTING
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK distributor, Sealey Group,
Kempson Way, suffolk Business Park ,
Bury st. Edmunds, suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
Original Language Version Dfs55 Issue: 2 - 17/02/10