Florabest FBKS 4015 - Manual (Page 3)

GB
3
IDENTIFICATION OF SYMBOLS
WARNING: Chain saws can be
dangerous! Careless or improper
use can result in serious or fatal
injury to the operator or others.
Please read the operator’s manual
carefully and make sure you
understand the instructions
before using the machine.
Always wear:
S Approved protective helmet
S Approved hearing protection
S Protective goggles or a visor
This product is in accordance with
applicable EC directives.
Noise emission to the
environment according to the
European Community’s
Directive. The machine’s
emission is specified in chapter
Technical data and on label.
Both of the operator’s hands must
be used to operate the chain saw.
Never operate a chain saw
holding it with one hand only.
Contact of the guide bar tip with
any object must be avoided.
WARNING! Kickback may occur
when the nose or tip of the guide
bar touches an object, and cause
a lightning fast reverse reaction,
kicking the guide bar up and to-
wards the operator. May cause
serious personal injury.
Chain brake, activated
(right)
Chain brake, not activated
(left)
Other symbols/decals on the machine
refer to special certification require-
ments for certain markets.
Oil/petrol mix
Switch off the engine by
moving the stop switch to
the STOP position before
carrying out any checks
or maintenance.
Starting reminder:
Move ON/STOP switch to
the ON position.
Slowly press primer bulb
6 times.
Pull the starter rope
sharply 5 times with your
right hand.
Pull the starter rope sharply
with your right hand until
the engine starts.
Pull choke/fast idle lever
out to the full extent (to
the FULL CHOKE posi-
tion).
Push the choke/fast idle
lever in to the HALF
CHOKE position.