Edirol R-4 - Manual (Page 61)

61
System settings
Rec Mode
MONOx1
One-channel recording to
one monaural file This selects the structure of the project file that is
created when you record. A monaural WAV file
will be created for each channel. Choose these
settings if you’re using a separate mic for the vo-
cal and performance or each speaker in a conver-
sation, so that a separate file will be created for
each channel. These settings will create monaural
WAVE files. If
Input Select is Analog , up to four
monaural files will be created. If Input Select is
Int-Mic or Digital , up to two monaural files will
be created.
* You can’t select MONO x3, or MONO x4, or
STEREO x2 if
Input Select is Int-Mic or Digital .
* You can’t select MONO x3 or MONO x4 if Rec
Freq. is 96 kHz .
MONOx2
Two-channel recording to
two monaural files
MONOx3
Three-channel recording to
three monaural files
MONOx4
Four-channel recording to
four monaural files
STEREOx1
Two-channel recording to
one stereo file
Two channels will be recorded as L and R in a ste-
reo WAV file.
If
Input Select is Analog , one stereo file with
channel 1 as L and channel 2 as R will be created.
The inputs of channels 3 and 4 will be ignored.
If Input Select is
Int-Mic or Digital , one stereo
WAV file will be created.
STEREOx2
Four-channel recording to
two stereo files
If Input Select is Analog, a stereo file with chan-
nel 1 as L and channel 2 as R will be created, and
another stereo file with channel 3 as L and chan-
nel 4 as R will also be created.
* You can’t select STEREO x2 if Input Select is
Int-
Mic or Digital .
4CHx1
Four-channel recording to
one four-channel file
Channels 1–4 will be recorded as a single WAVE
file. Be aware that not all computer software is
able to handle four-channel WAV files.
* You can’t select 4CH x1 if
Int-Mic is set to Digi-
tal .
The “*” symbol means that this is not available if Input Select is set to Int-Mic or Digital.
Pre Record-
ing OFF , 1–29
sec
You can specify the length of time that the sound will be captured “retroactive-
ly,” starting from before the moment you pressed the [REC] (record) button.
This setting specifies the number of seconds that will be captured retroactively.
* The maximum time will depend on the sampling frequency, the sample size
(bit depth), and the mode setting.
* The R-4 consumes power even during pre-recording. If you’re running on bat-
teries, you’ll need to pay attention to the remaining battery amount.
Menu item Value Function
MONOx1 MONOx2 MONOx3 MONOx4 STEREOx1 STEREOx2 4CH
44.1kHz
48kHz
96kHz ✽
✽
✽ ✽
✽ ✽
✽ ✽
✽
✽
Rec Freq. Rec Bit Rec Mode Pre Recording
44.1
44.1
48
48
48
48
96
96
16
16
16
16
24
24
24
24 29
14
27
13
18
9
9
4
STEREO x1
STEREO x2
STEREO x1
STEREO x2
STEREO x1
STEREO x2
STEREO x1
STEREO x2
R-4_e.book 61 ページ ２００５年２月１０日 木曜日 午後３時３６分