Edirol R-4 - Manual (Page 19)

19
Introducing the R-4
In the main screen, you can press the [DISPLAY] button to switch the progress bar area so it shows the
remaining project time (REMAIN).
fig.play-disp2.eps
The mixer screen
From the main screen, press the [DISPLAY] button twice to move to the Mixer screen.
This screen lets you adjust the volume balance for monitoring.
fig.play-disp3.eps
Output level meters These are the output level meters. They show the final output levels of the L
and R channels, to which the various channels have been mixed. You can use
the monitor level sliders of the mixer screen to adjust the level of each channel.
From the left, the level meter is calibrated at -36, -24, -12, and -6 dBFS.
Clip level indicators
Power source
Indicates how power is being supplied to the R-4. The plug icon is shown if
power is being supplied by the AC adaptor, and the battery icon is shown if
power is being supplied by batteries.
Remaining time
During playback, this indicates the remaining time from the current location
to the end of the project.
Channel level sliders
Use these to adjust the playback level of each channel. Use the left/right
[CURSOR/FINDER] buttons to select a slider, and turn the [SCRUB/VALUE]
dial to adjust the value. Each slider provides adjustment within the range 0–
120. The default value is 100.
* The settings are not stored in the project; they are remembered by the R-4
itself. When you turn off the power, the settings will revert to their default
values.
* These settings do not affect the recording levels.
Remaining time
Channel names
Channel level meters
Channel level
sliders
Output level meters
Monitor output indicators
R-4_e.book 19 ページ ２００５年２月１０日 木曜日 午後３時３６分