Eiki LC-X2U - Manual (Page 50)

This projector has other functions setting: Blue back, Display, Reverse T/B,
Reverse R/L, Split wipe, Power management, USB, Remote control and
Lamp age.
When this function is in the “On” position, the projector will project a blue image
without video noise on the screen when the video source is unplugged or turned
off.
When this function is in the “On” position, on-screen displays always appear when adjustments are made. Although
these on-screen displays are very helpful, these may spoil the view if adjustments are made during presentations.
To avoid this, you can keep back certain displays by switching this function “Off”. The followings are the displays
that you can hide.
• Wait Display
•
Mode Display
•
Volume Display
• Mute Display
•
Zoom/Focus/Lens shift Display
•
D.Zoom Display
• Normal Display
•
No show Display
When this function is in the “On” position, the top/bottom-picture reverse.
When this function is in the “On” position, the left/right picture reverse
capability lets you project onto a rear projection screen.
Turn SPLIT WIPE function On in the SETTING menu. The picture will change into next one by sliding black image
side ways when the input source is changed.
Change the input source by MODE button. The picture is replaced by black image from side ways to the center, and
the next one appears from the center to side ways like drawing the black curtains.
Power management will be turn the projector Lamp off when the input signal is interrupted (Picture is not displayed)
over 5 minutes. This aims at saving power and Lamp life. The Lamp is automatically turned on when the signal is
input. To activate this function, turn the “Power management” in the SETTING menu “On”.
This Projector is designed for connecting with SUB Port of the computer or peripheral equipment that is to be
standard.
When this function is in the “ “ (Mouse) position, you control the pointer of the computer using the projector’s
wireless remote control unit.
When this function is in the “ “ (Control) position, you control the projector by computer.
NOTE: Before you control the projector by computer, install USB driver )optionally saled parts) and set up the
computer following instruction in the USB driver package. Contact your authorized dealer.
Turn SPLIT WIPE function On in the SETTING menu. The picture will change into next one by sliding black image
side ways when the input source is changed.
When this function is in the “On” position, the left/right picture reverse capability Turn SPLIT WIPE function On in the SETTING menu. The picture will change into next one by sliding black image
side ways when the input source is changed.