Eiki LC-X2U - Manual (Page 13)

Pin No./Signal
1 Red input
2 Green input
3 Blue input
4 Sense 2
5 Ground (Horiz.sync.)
6 Ground (Red)
7 Ground (Green)
8 Ground (Blue)
Pin No./Signal 9 Non
Connect
10 Ground (Vert. sync.)
11 Sense 0
12 Sense 1
13 Horiz. sync
14 Vert. sync
15 Reserved
These jacks will contain the audio information of the selected program source being viewed on the screen
(Computer 1,
Computer 2, Video 1 or Video 2). If you have selected program source Computer 2 the audio signal
connected to the
Computer 2 audio input jack will be available at the audio monitor output jacks.
Use RCA type audio for connection.
• If the audio input of the audio equipment is stereo, be sure to connect the right and left channels to the
respective right and left jacks.
• If the audio input of the audio equipment is monaural, connect it to the left jack.
CONNECTING TO THE SERIAL PORT (DB 9-PIN) TERMINAL
If you control the. projector by computer, you must connect a cable
(not provided) from your computer to this terminal.
CONNECTING TO THE USB PORT CONNECTORS (1 and 2)
This Projector is designed for connecting with USB Port of the computer or peripheral equipment that is to be standard.
This terminal output the information of the selected computer source being viewed on the screen
(Computer 1 or Computer 2).
When video source (“Video 1” or “Video 2”) is selected, this terminal outputs Computer 1 input
information.
An external monitor can be connected to the HDB15-pin (VGA) terminal on the projector.
• Connect the monitor to this terminal usinq the VGA cable (not provided).