Eiki LC-X2U - Manual (Page 47)

17. Another dialog box “PC ADJUSTMENT DISPLAY 2” will appear and the parameter data for the Mode you
have selected is shown in this dialog box.
p18. Move the arrow to an item that you want to adjust by pressing the POINT UP/DOWN BUTTON(s).
19. To increase the level, point the arrow to S and then press the SELECT (REAR CLICK) BUTTON. To
decrease the level, point the arrow to T and then press the SELECT (REAR CLICK) BUTTON.
20. If you want to store the settings in the memory, move the arrow to Stored and press the SELECT (REAR
CLICK) BUTTON. When you have stored the settings, “OK ?“ is displayed for confirmation. Move the arrow to
Yes and then press the SELECT (REAR CLICK) BUTTON.
21. To recall the parameter data before setting, move the arrow to Reset and then press the SELECT (REAR
CLICK) BUTTON. When you have reset the settings, “OK ?“ is displayed for confirmation. Move the arrow to
Yes and then press the SELECT (REAR CLICK) BUTTON. You can adjust the settings again if needed.
22. To quit the MENU, move the arrow to Quit and then press the SELECT (REAR CLICK) BUTTON.
23. If you quit the MENU without storing the settings in the memory, the parameter data you changed will not be-
kept.
24. The stored settings are memorized even if the MAIN ON/OFF is switched off.
ITEM FUNCTION
CLAMP
Adjustment of the clamp level. When the image has a dark bar, try this adjustment.
FINE SYNC Adjust the picture as necessary to eliminate flicker from the display.
DISPLAY AREA Adjustment the display area to match your PC.
HORIZ. SCALE Expanding or compressing level for the horizontal direction.
VERT. SCALE Expanding or compressing level for the vertical direction.