Epson LT - 286e - Manual (Page 63)

Install the appropriate keyboard information for the country
in which you’re using your computer
Allow you to start the MS-DOS Shell program.
These instructions ensure that your system starts up properly
each time you boot it from the hard disk. See your MS-DOS
Installation Guide for details.
You’ll also want to add the SETLCD and HDDPSAVE utilities
to your AUTOEXEC.BAT file. By adding these utilities, you
can set the backlight period for the LCD screen and the power-
off period for the hard disk each time you power on the
computer. Also, by adding the SETLCD utility to the
AUTOEXEC.BAT file, you can modify the gray-scale modes at
any time.
To modify the AUTOEXEC.BAT file created by SELECT,
follow these steps:
1.
Type
COPY AUTOEXEC.BAT + CON
AUTOEXEC.BAT
and press Enter.
2.
Type
SETLCD /5
and press Enter. This turns off
backlighting after five minutes. Use any time period you
want (between 1 and 60).
3.
Type
HDDP SAVE / 5
and press Enter. This turns off
power to the hard disk if you do not access the hard disk
for five minutes. Use any time period you want (between
1 and 18).
4. Press F6 and then Enter.
2-26
Using the Equity LT-286e