Chap 1-setting up your system, Setting up your system, Chapter 1 – Epson LT - 286e User Manual
Page 16
Chapter 1
Setting Up Your System
Setting up your Epson Equity LT-286e portable computer is easy.
Just follow the steps in this chapter. They describe how to
attach the hard disk, connect a printer, and attach the AC
adapter and power cord that come with your Equity LT-286e.
After assembling these parts, you start the computer and run the
system SETUP program.
After you perform these steps, turn to Chapter 2 for information
about using the computer.
The LT-286e has two sets of switches that provide the computer
with information about its configuration each time you turn it
on. The switches are called DIP switches and slide switches.
Both sets of switches are located on the bottom of the
computer.
When the LT-286e is shipped from the factory, these switches
are set for the following type of system:
The internal diskette drive is drive A
The LCD screen is set for EGA mode
The slide switch is set for the LCD screen
The serial port is the primary serial port
The parallel port is the primary parallel port
The CPU clock speed is 12 MHz.
If you plan to use this standard setup, continue with the
instructions in this chapter.
Setting Up Your System
1-1