E-Tech STYLUS Pro WT7900 - Manual (Page 99)

99
Maintaining and Transporting the Printer | 99
Cleaning the Printer
To keep your printer working at its best, clean it if it becomes soiled.
1. If your prints are soiled by ink on the paper feed rollers, load inexpensive
roll paper and press d to feed the paper without printing on it. Press d
several times until the paper is clean. When done, press the
button
to cut and remove the soiled paper.
2. Turn off the printer and wait until all the lights are off. Then unplug the
power cord and disconnect the printer from your system.
3. Open the front cover and use canned air or a soft lint-free cloth to
carefully clean away any dust or dirt inside the printer.
4. If your prints are soiled on the back, carefully wipe the area shown below
in blue. If necessary, dampen the cloth, clean the inside of the printer,
then dry it with a soft cloth.
Caution: Do not touch
the paper feed rollers or
absorption pads inside
the printer, or your prints
may get soiled.
To avoid damaging the
components as well as
the case, never use
alcohol or thinners to
clean the printer.
Be careful not to get
water on the printer
mechanism or electronic
components.
Don’t use a hard or
abrasive brush.
Don’t spray the inside
of the printer with
lubricants; unsuitable
oils can damage the
mechanism. Contact
Epson if you think the
printer needs lubrication.