E-Tech STYLUS Pro WT7900 User Manual
Page 93
93
Maintaining and Transporting the Printer
|
93
3. Use the d and u buttons to select the settings described below. If you
need to back up to the previous menu level, press l.
•
To change the language on the LCD display, press d to highlight
LANGUAGE
, then press r. Press d until you see the language you
want, then press
OK
to select it. The printer exits maintenance
mode and returns to normal operation.
•
To change the units of measurement, press d
to highlight
LENGTH
UNITS
, then press r. Press d to switch from
METRIC
to
FEET/INCH
, then press
OK
to select it. Press
l
when done.
•
To change the temperature units of measurement, press d
to
highlight
TEMPERATURE UNITS
, then press r. Press d to switch
from
C
(Celsius or centigrade)
to
F
(Fahrenheit), then press
OK
to
select it. Press
l
when done.
•
To change the maximum roll paper tension, press d to highlight
ROLL PAPER TENSION
, then press
r
. Press d to decrease the
maximum value, or u
to increase it (from 1 to 5). The default
setting is 3. Press
OK
to select the setting you want.
•
To run a super strong cleaning cycle, press d to highlight
SS CLEANING
, then press r
to display
EXECUTE
. Press
OK
to
start the cleaning cycle.
•
To return all control panel settings to their default values, press d
to
highlight
DEFAULT PANEL
, then press r
to display
EXECUTE.
Press
OK
to restore the default settings.
•
To change the number of times the printer cleans the print head
after it performs a nozzle check and finds blocked nozzles, press d
to highlight
AUTO CLEANING TIMES
, then press r. Press u
to d
to change the setting (from 1 to 3), then press
OK
to save the
setting. The default setting is 1 (recommended).
4. To exit maintenance mode, turn off the printer by pressing the P power
button. Press the P power button again to turn on the printer in the
normal operating mode.
Note: The CUSTOM
setting in maintenance
mode is not normally
used.